Published

2018-10-01

Study on Fatigue Life of Fractured Rock Under Constant Amplitude Cyclic Loading

Estudio sobre la vida a la fatiga de rocas fracturadas bajo cargas cíclicas de amplitud constante

Keywords:

fractured rock, dynamic loading, fatigue life, S-N curve (en)
roca fracturada, carga dinámica, vida a la fatiga, curva S-N (es)

Downloads

Authors

  • Run Li Engineering college, Fujian Jiangxia University, Fuzhou 350108, China;
  • Wenbin Jian College of Environment and Resources, Fuzhou University, Fuzhou 350116, China
  • Rongtao Kang Fuzhou Architecture Design Institute, Fuzhou 350011, China
The electro-hydraulic servo loading system was applied to make cyclic loading tests for fractured rock-like specimens. According to the results of the fatigue test, the power function model was used to fit and analyze the test data, and the fitting degree of the curve was determined by the correlation coefficient, and the result was fitted well. The main factors influencing the fatigue life of specimens were analyzed. The upper limit stress was the most important factor affecting the fatigue life of specimens. Under the same conditions, the specimen had a shorter fatigue life when being applied by higher upper limit stress; the rock of different types and strengths not only had different fatigue life, but also had the different sensitive degrees between the fatigue life and the upper limit stress; the fatigue life of specimens was significantly influenced due to different initial damages.

El sistema electrohidráulico de carga servo se aplicó para realizar pruebas de carga cíclicas para muestras de roca fracturada. De acuerdo con los resultados de la prueba de fatiga (resistencia a la fatiga), el modelo de función de potencia se utilizó para ajustar y analizar los datos de la prueba; el grado de ajuste de la curva se determinó mediante el coeficiente de correlación, y se ajustó el resultado. Se analizaron los principales factores que influyen en la resistencia a la fatiga de las muestras. La tensión límite superior fue el factor más importante que afectó la vida a la fatiga (resistencia de fatiga) de las muestras. En las mismas condiciones, el espécimen tuvo una vida a la fatiga más corta cuando se aplicó por un límite superior de tensión; la roca de diferentes tipos y fuerzas no solo tuvo una vida a la fatiga diferente, sino que también tuvo diferentes grados de sensibilidad entre la vida a la fatiga y la tensión límite superior; la vida a la fatiga de los especímenes fue significativamente influenciada debido a diferentes daños iniciales.

Downloads

Download data is not yet available.

References

Cao, P., Liu, T. & Pu, C. (2015). Crack Propagation and Coalescence of Brittle Rock-like Specimens with Pre-existing Cracks in Compression. Engineering Geology, 187, 113-121.

Erarslan, N. & Williams, D. (2012). The Damage Mechanism of Rock Fatigue and its Relationship to the Fracture Toughness of Rocks. International Journal of Rock Mechanics and Mining Sciences, 56, 15-26.

Haeri, H., Shahriar, K. & Marji, M. F. (2014a). Experimental and Numerical Study of Crack Propagation and Coalescence in Pre-cracked Rock-like Disks. International Journal of Rock Mechanics and Mining Sciences, 67, 20-28.

Haeri, H., Shahriar, K. & Marji, M. F. (2014b). On the Strength and Crack Propagation Process of the Pre-cracked Rock-like Specimens under Uniaxial Compression. Strength of Materials, 46, 140-152.

JinJin, Cao, P. & Pu. C. (2014). Influence of Flaw Parameters on Damage Mode and Strength of Rock-like Materials (in Chinese). Changsha, China: Journal of Central South University (Science and Technology), 45(2), 529-535.

Momeni, A., Karakus, M., & Khanlari, G. R. (2015). Effects of Cyclic Loading on the Mechanical Properties of a Granite. International Journal of Rock Mechanics and Mining Sciences, 77, 89-96.

Pu, C., & Cao, P. (2012). Failure Characteristics and its Influencing Factors of Rock-like Material with Multi-fissures under Uniaxial Compression. Transactions of Nonferrous Metals Society of China, 22, 185-191.

Shilei, K., Junsheng, Y., & Feng, Y., (2016). Macro-and-meso Analysis of Failure Behavior of Rock-like Samples with Flaws Using a Numerical Method (in Chinese). Journal of Yangtze River Scientific Research Institute, 33(4), 71-77.

Xiufeng, F. (2008). Study on the Damage Evolution of Rock Fatigue and the Response of Rock Slope under Cyclic Loading (in Chinese). Fuzhou, China: Fuzhou University.

Xiurun, G. (1987). Study on Deformation and Strength Behaviour of the Large-sized Triaxial Rock Samples under Cyclic Loading (in Chinese). Rock and Soil Mechanics, 8(2), 11-19.

Xiurun, G. & Yingfa, L. (1992). Discussion on the Problem of Rock Fatigue Failure and Irreversible Deformation under Cyclic Loading (in Chinese). Chinese Journal of Geotechnical Engineering, 14(3), 56-60.

Xiurun, G., Yu, J. & Yunde, L. (2003). Testing Study on Fatigue Deformation Law of Rock under Cyclic Loading (in Chinese). Chinese Journal of Rock Mechanics and Engineering, 22(10), 1581-1585.

Yanbo, Z., Xing, H. & Guo, J. (2017). Experimental Study of Fatigue Characteristics of Gypsum Rock under Cyclic Loading (in Chinese). Chinese Journal of Rock Mechanics and Engineering, 36(4), 940-952.

Yu, J. (2003). Fatigue Failure and Deformation Development Law of Rock under Cyclic Load (in Chinese). Shanghai, China: Shanghai Jiaotong University.

Zhou, X. P., Cheng, H. & Feng Y. F. (2014). An Experimental Study of Crack Coalescence Behaviour in Rock-Like Materials Containing Multiple Flaws Under Uniaxial Compression. Rock Mechanics and Rock Engineering, 47, 1961-1986.